Commercial Washer Repair in Colorado Springs

A down washer in a laundromat is lost income; in a hotel or a gym it means running out of clean linens. Best Pro repairs commercial washers for laundromats, hotels, gyms, salons, care homes and other businesses with on-premise laundry across the Colorado Springs area.

Washers we repair

• Front-load and top-load coin and card-operated washers
• Soft-mount washer-extractors that stand on their own suspension
• Hard-mount washer-extractors bolted to a concrete base
• Stacked commercial washer-dryers

Common failures

• Door won’t lock, or stays locked. The door lock is the most frequently replaced part on a busy front-loader. The washer won’t start until the controller sees the door locked.
• Not draining. Many washer-extractors drain by gravity through a drain valve rather than a pump. A stuck valve or a clog in the drain trough leaves water in the drum and stops the extract.
• Out-of-balance shutdowns or violent shaking. Worn shock absorbers or springs on soft-mount machines; loose anchor bolts or a cracked concrete base under hard-mount machines.
• Loud roar during extract. High extract speeds are hard on bearings and seals. Replacing them early prevents damage to the shaft and drum.
• Leaking. A worn door gasket, a drain valve that doesn’t seal, or a failed tub seal.
• Drive fault codes. Most modern washer-extractors run on a variable-frequency drive. We check the motor, the drive and the wiring before replacing anything expensive.

Chemical injection pumps connected to the washer are usually maintained by your chemical supplier; we check the washer side of the connection.

You get the price before any work starts and a 6-month warranty on parts and labor. For your dryers, see commercial dryer repair; for home washers, see washer repair.